I had read the earlier reviews on Amazon and had decided that I will not read the instructions prior to the install to determine how intuitive this system really was? The only exception I would allow myself was if the wiring was significantly different from my old unit - which it was not!
The setup was relatively simple. Removed the old unit and replaced it with the new back plate and accent bezel. No new holes to drill. The accent bezel is the closest piece to the wall and is held up by the back plate. I straightened the old wires, inserted into the corresponding clamp and tightened the screws - Total time of 15 minutes.
I inserted 2 new alkaline batteries (And NO, I did not use the recommended Duracell or Energizer!) and the unit came to life. I clicked on the time and it started beeping. I could see arrows on the right and intuitively touched them to set the time. Did the same to set the day. Touching the 'Menu' got me into the programming mode for the unit. I touched "SCROLL" to skip to the next feature, and "NEXT" for the next step in the feature programming. I do admit I took a few iterations to get used to the programming logic. Also 'YES' to accept settings is a little different from the colloquial "ENTER" we are used to in a computer literate world!
This unit is programmable for every day of the week. I, at most, need one setting for all week-days and one each for Sat and Sun. While programming the days, I noticed that they had a "COPY" function. I was sure that this was to copy my settings - every time I touched it, it went over to the next day. I thought that the data was being copied over and I did verify it after I completed my first iteration of programming. By the way, once you are in the programming mode, setting the start time for any period and/or setting the temperature is as simple as touching the time or temperature and using the up/down arrows. Could not be simpler!
I was fortunate that I had the program settings available from my old unit - once I went through a few iterations of errors (not using "YES" to accept settings!) the unit was programmed - Total time of 15 minutes More Detail>>>>
0 comments:
Post a Comment